HomeMy WebLinkAboutOC_RS060070 - MiscMANDATORY MEASURES CHECKLIST: RESIDENTIAL MF -1R Page 3
Project Title.......... Buckley Residence Date..11/22/05 13:02.11
I MICROPAS7 v7.10 File-BUCKLEYI Wth-CTZ06S05 Program -FORM MF -1R I
I User#-MP0408 User -Donn C. Gilmore & Assoc., Run -Buckley I
150(k)1: HIGH EFFICACY LUMINAIRES OTHER THAN OUTDOOR HID:
contain only high efficacy lamps as outlined in Table
150-C, and do not contain a medium screw base socket
(E24/E26). Ballast for lamps 13 watts or greater are electronic
UL 181A, or UL 181B or aerosol sealant that meets the
requirements of UL 723. If mastic or tape is used to seal
openings greater than 1/4 inch, the combination of mastic
and either mesh or tape shall be used
_
2.
Building cavities, support platforms for air handlers, and
plenums defined or constructed with materials other than
sealed sheet metal, duct board or flexible duct shall not
be used for conveying conditioned air. Building cavities and
support platforms may contain ducts. Ductsinstalled in
cavities and support platforms shall not be compressed to cause
reductions in the cross-sectional area of the ducts
X
3.
Joints and seams of duct systems and their components
shall not be sealed with cloth backed rubber adhesive
duct tapes unless such tape is used in combination with
mastic and draw bands
4.
Exhaust fan systems have back draft or automatic dampers
_
5.
Gravity ventilating systems serving conditioned space have
either automatic or readily accessible, manually
operated dampers
_
6.
Protection of Insulation. Insulation shall be protected
from damage due to sunlight, moisture, equipment mainten-
ance and wind. Cellular foam insulation shall be protected
as above or painted with a coating that is water retardant
and provides shielding from solar radiation that can cause
degradation of the material
7.
Flexible ducts cannot have porous inner cores
114:
Pool and Spa Heating Systems and Equipment
1.
A thermal efficiency that complies with the Appliance
Efficiency Regulations, on-off switch mounted outside of
the heater, weatherproof operating instructions, no
electric resistance heating and no pilot light
2.
System is installed with:
a. At least 36 inches of pipe between filter and heater
for future solar heating
b. Cover for outdoor pools or outdoor .spas.
3.
Pool system has directional inlets and a circulation
pump time switch
_
115:
Gas-fired central furnaces, pool heaters, spa heaters or
household
cooking appliances have no continuously burning
pilot light (Exception: Non -electrical cooking appliances
with pilot < 150 Btu/hr)
118(1): Cool Roof material meets specified criteria _Y
RESIDENTIAL LIGHTING MEASURES
De- En-
sign- force
n/a
er ment
150(k)1: HIGH EFFICACY LUMINAIRES OTHER THAN OUTDOOR HID:
contain only high efficacy lamps as outlined in Table
150-C, and do not contain a medium screw base socket
(E24/E26). Ballast for lamps 13 watts or greater are electronic
MANDATORY MEASURES CHECKLIST: RESIDENTIAL
MF -1R Page 4
----------------------------------------------------------------------------
Project Title.......... Buckley Residence Date..11/22/05 13.02:11
MICROPAS7 v7.10 File-BUCKLEYI Wth-CTZ06S05 Program -FORM MF -1R
User#-MP0408 User -Donn C. Gilmore & Assoc., Run -Buckley
---------------------------------------------------------
and have an output frequency no less than 20 kHz
150(k)l: HIGH EFFICACY LUMINAIRES - OUTDOOR HID: contain
only high efficacy lamps as outlined in Table 150-C,
luminaire has factory installed HID ballast
150(k)2: Permanently installed luminaires in kitchens shall
be high efficacy luminaires. Up to 50 percent of the wattage,
as determined in Sec. 130(c), of permanently installed luminaires
in kitchens may be in luminaires that are not high efficacy
luminaires provided that these luminaires arecontrolled
by switches separate from those controlling the high
efficacy luminaires
150(k)3: Permanently installed luminaires in bathrooms,
garages, laundry rooms, utility rooms shall be high
efficacy luminaires OR are controlled by an occupant
sensor(s) certified to comply with Section 119(d) that
does not turn on automatically or have an always on option
150(k)4: Permanently installed luminaires located other than
in kitchens, bathrooms, garages, laundry rooms, and utility
M
rooms shall be high efficacy luminaires (except closets
less than 70 ft2), OR are controlled by a dimmer switch
OR are controlled by an occupant sensor(s) that complies
with Section 119(d) that does not turn on automatically
or have an always on option
150(k)5: Luminaires that are recessed into insulated ceilings
are approved for zero clearance insulation cover (IC) and
are certified air tight to ASTM E283 and labeled as air
tight (AT) to less than 2.0 CFM. at 75 Pascals
-
150(k)6: Luminaires providing outdoor lighting and permanently
mounted to a residential building or to other buildings on
the same lot shall be high efficacy luminaires (not in-
cluding lighting around swimming pools/water features or
other Article 680 locations) OR are controlled by occupant
sensors with integral photo control certified to comply
with Section 119(d)
150(k)7: Lighting for parking lots for 8 or more vehicles shall
—
have lighting that complies with Sec. 130, 132, and 147.
Lighting for parking garages for 8 or more vehicles shall
have lighting that complies with Sec. 130, 131, and 146
—
150(k)8: Permanently installed lighting in the enclosed, non -
dwelling spaces of low-rise residential buildings with four
or more dwelling units shall be high efficacy luminaires OR
are controlled by an occupant sensor(s) certified to
comply with Section 119(d) /�